SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 142 (POWER STEERING SYSTEM)COMPONENT LOCATORPOWER STEERING CONNECTORSPOWER STEERING CONTROL MODULE (PSCM) C3
2006 Isuzu Ascender S, 5.3 M, 4WD

Power Steering Control Module (PSCM) C3

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Power Steering Control Module (PSCM) C3
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Power Steering Control Module (PSCM) C3 Connector End View
GM1881391Courtesy of GENERAL MOTORS CORP.
Power Steering Control Module (PSCM) C3 Connector Parts Information

Connector Part Information 
  • OEM: 1747088-1
  • Service: Service by Harness - See Part Catalog
  • Description: 8-Way F 0.64 Series (NA)
Terminal Part Information 
  • Pins: 1, 2
  • Terminal/Tray: See Catalog
  • Core/Insulation Crimp: See Catalog
  • Release Tool/Test Probe: See Catalog
Power Steering Control Module (PSCM) C3 Connector Terminal Identification

Pin Wire Color Circuit No. Function
1 RD - Torque Sensor GND
2 WH - Torque Sensor Exciting GND
3 - - Not Used
4 D-GN - Torque Sensor Exciting
5 L-BU - Torque Sensor Output Shaft Side COS
6 YE - Torque Sensor Output Shaft Side SN
7 BK - Torque Sensor Input Shaft Side COS
8 PK - Torque Sensor Input Shaft Side SN
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.