Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 136 (ENGINE COOLING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Condenser to Radiator Bolts | 9 N.m | 80 lb in |
| Coolant Heater | 50 N.m | 37 lb ft |
| Cooling Fan Motor Bolts | 6 N.m | 53 lb in |
| CRFM Bracket Bolts | 20 N.m | 15 lb ft |
| Fan Shroud to Radiator Bolts | 9 N.m | 80 lb in |
| Heater Inlet Pipe Nut | 25 N.m | 18 lb ft |
| Heater Outlet Pipe to Throttle Body Bolt | 10 N.m | 89 lb in |
| Heater Outlet Pipe to Throttle Body Nut | 10 N.m | 89 lb in |
| Heater Outlet Pipe to Upper Intake Manifold Nut | 25 N.m | 18 lb ft |
| Manifold Absolute Pressure (MAP) Sensor Bracket Bolt | 10 N.m | 89 lb in |
| Surge Tank to Body Bolts | 9 N.m | 80 lb in |
| Thermal Bypass Fitting Bolt | 12 N.m | 106 lb in |
| Thermal Bypass Pipe Bolt | 10 N.m | 89 lb in |
| Thermostat Housing Bolt | 25 N.m | 18 lb ft |
| Water Pump Bolt | 10 N.m | 89 lb in |
| Water Pump Pulley Bolt | 25 N.m | 18 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.