Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 128 (WIPER SYSTEM & WASHER SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2006 Isuzu Ascender S, 5.3 M, 4WD
Scan Tool Output Controls
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Scan Tool Output Controls
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Body Control Module (BCM)
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Wiper Test | Front Wiper Relay | The wiper switch has to be in the Low position for this output control to function. The BCM actuates the Wiper relay when ON is selected. The front wiper should operate at low speed. |
| Wiper Test | Rear Wiper Relay | The wiper switch has to be in the Low position for this output control to function. The BCM actuates the Wiper relay when ON is selected. The rear wiper should operate at low speed. |
| Wiper Washer Test | Wiper Washer Motor | The BCM will command the FRT WASHER PCB relay ON, activating the washer pump. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.