SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC P0621: GENERATOR L-TERMINAL CIRCUITTEST DESCRIPTION
2006 Isuzu Ascender S, 5.3 M, 4WD

Test Description

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Test Description
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0621

Step Action Yes No
Schematic Reference: Starting and Charging Schematics 
Connector End View Reference:  Engine Electrical Connector End Views  
1 Did you perform the Engine Electrical Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Engine Electrical 
2
  1. Install a scan tool.
  2. Start the engine.
  3. With a scant tool, monitor the DTC information for DTC P0621 in Engine Controls.
Does the scan tool indicate that DTC P0621 has passed?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Test the generator turn on signal circuit for a short or open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 6  Go to Step 4 
4 Inspect for poor connections at the harness connector of the PCM. Refer to Connector Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 6  Go to Step 5 
5 Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement in Engine Controls - 4.2L.
Did you compete the replacement?		 Go to Step 6  -
6
  1. Review and record the scan tool Fail Records data.
  2. Clear any DTCs.
  3. Operate the vehicle within the Fail Records conditions as noted.
  4. Using a scan tool, monitor the Specific DTC info for this DTC.
Does the scan tool indicate that this DTC failed this ignition?		 Go to Step 2  System OK
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.