Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2006 Isuzu Ascender S, 5.3 M, 4WD
Fastener Tightening Specifications
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Air Conditioning (A/C) Evaporator Line to Battery Tray Nut | 15 N.m | 11 lb ft |
| Battery Tray Bolt | 15 N.m | 11 lb ft |
| Battery Hold Down Bolt | 15 N.m | 11 lb ft |
| Battery Negative Cable Terminal Bolt | 17 N.m | 13 lb ft |
| Battery Positive Cable Terminal Bolt | 17 N.m | 13 lb ft |
| Battery Tray Support Bracket Bolt | 25 N.m | 18 lb ft |
| Coolant Surge Tank Bolt | 6 N.m | 53 lb in |
| Generator Battery Positive Terminal Nut | 20 N.m | 15 lb ft |
| Generator Bolt | 50 N.m | 37 lb ft |
| Generator Bracket Bolt | 50 N.m | 37 lb ft |
| Negative Battery Cable to Inner Fender Bolt | 12 N.m | 106 lb in |
| Negative Battery Cable to Transaxle Nut | 45 N.m | 33 lb ft |
| Remote Battery Terminal Nut | 17 N.m | 13 lb ft |
| Starter Solenoid Positive Battery Terminal Nut | 10 N.m | 89 lb in |
| Starter Solenoid S Terminal Nut | 3 N.m | 27 lb in |
| Starter-to-Engine Bolt | 43 N.m | 32 lb ft |
| Torque Converter Shield Bolt | 8 N.m | 71 lb in |
| UHFB Connector Bolt | 4 N.m | 35 lb in |
| Under Hood Fuse Block (UHFB) Battery Positive Terminal Nut | 15 N.m | 11 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.