SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 109 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSGENERATOR REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Removal Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Pontiac Torrent and 2007 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery ground (negative) cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
    2. Fig 1: View Of Generator B+ Terminal Nut, B+ Lead & Electrical Connector
    GM1317263Courtesy of GENERAL MOTORS CORP.
  2. Remove the generator B+ terminal nut.
  3. Remove the generator B+ lead.
  4. Remove the generator electrical connector.
  5. Remove the drive belt from the generator. Refer to Drive Belt Replacement .
    6. Fig 2: View Of Generator & Bolts
    GM1317267Courtesy of GENERAL MOTORS CORP.
  6. Remove the generator bolts.
  7. Remove the generator from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.