Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMDIAGNOSTIC INFORMATION & PROCEDURESSCAN TOOL OUTPUT CONTROLS
2006 Isuzu Ascender S, 5.3 M, 4WD
Scan Tool Output Controls
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Scan Tool Output Controls
Body Control Module
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Miscellaneous Test | Rear Door Lock/Unlock | The BCM actuates the door lock relay when you select Lock. Rear doors should lock. The BCM actuates the door unlock relay when you select Unlock. Rear doors should unlock. |
| Miscellaneous Test | Left Rear Window | The BCM will control the left window up when you select Up. The BCM will control the left window down when you select Down. |
| Miscellaneous Test | Right Rear Window | The BCM will control the right window up when you select Up. The BCM will control the right window down when you select Down. |
Driver Door Module and Passenger Door Module
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Output Control | Window Up/Down | The DDM or PDM will command the window up and down |
| Output Control | Door Lock Unlock Test | The DDM or PDM will command the door lock actuator to lock or unlock |
| Output Control | Mirror Left/Right | The DDM or PDM will command the mirror left and right |
| Output Control | Mirror Up/Down | The DDM or PDM will command the mirror up and down |
| Output Control | Mirror Fold | The DDM or PDM will command the mirror to move in or out |
| Output Control | Mirror Heat | The DDM or PDM will command the mirror heater on and off |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.