Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSLUMBAR SUPPORT CABLE REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD
Removal Procedure
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Removal Procedure
- Remove the seat assembly from the vehicle. Refer to Seat Replacement - Front Bucket .
- Remove the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
- Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
- Pull the cover half-way up the seat back.
- Remove the lumbar cable (2) from the cable clip (1) located on the lower seat back.
- Pull the seat back panel and pad away from the frame to expose the lumbar mechanism.
- Remove the cable from the lumbar spring.
- Unhook the cable end from the lumbar mechanism.
- Remove 2 screws (1) securing the cable to the seat adjuster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.