Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST
2006 Isuzu Ascender S, 5.3 M, 4WD
Scan Tool Data List
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Scan Tool Data List
Body Control Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/No Switches ON | |||
| Front Wipers Active | Inputs | Yes/No | No |
| Headlamp Wash | Inputs | On/Off | Off |
| Headlamp Wash | Outputs | On/Off | Off |
| Rear Washer Requested | Outputs | Yes/No | No |
Liftgate Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/No Switches ON | |||
| Rear Washer Requested | Data | Yes/No | No |
| Rear Wiper Mode | Data | Off/Delay 1/Delay 2/On/Wash | Off |
| Requested Rear Wiper | Data | Off/Delay 1/Delay 2/On/Wash | Off |
| Liftgate Ajar Switch | Data | Closed/Ajar | Closed |
| Liftglass Ajar Switch | Data | Closed/Ajar | Closed |
Endgate Module
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/No Switches ON | |||
| Rear Wiper | Input/Output | Park/Active | Park |
| Requested Rear Wiper | Input/Output | Off/Delay 1/Delay 2/On/Wash | Off |
| Rear Wiper Relay Cmd. | Input/Output | Off/Delay 1/Delay 2/On/Wash | Off |
| Lower Left Ajar Switch | Input/Output | Closed/Ajar | Closed |
| Upper Left Ajar Switch | Input/Output | Closed/Ajar | Closed |
| Upper Right Ajar Switch | Input/Output | Closed/Ajar | Closed |
| Upper Left Dome Lamp Switch | Input/Output | Closed/Ajar | Closed |
IPC
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/No Switches ON | |||
| Low Washer Fluid | Inputs/Output | OK/Low | OK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.