SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR COMMUNICATION SYSTEMSREPAIR INSTRUCTIONSONSTAR MICROPHONE REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 5.3 M, 4WD

Installation Procedure

2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Installation Procedure
    Fig 1: Quick Release Tab On Microphone
    GM754990Courtesy of GENERAL MOTORS CORP.
  1. If installation of the mounting bracket is required, install the mounting bracket to the overhead console.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 2 OnStar® microphone retaining screws.

    Tighten:  Tighten the screws to 0.8 N.m (7 lb in).

  3. Install the microphone to the mounting bracket ensuring the quick release tab (1) is fully seated.
    4. Fig 2: Connecting OnStar Microphone Electrical Connector
    GM741633Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the OnStar® microphone (1).
  5. Install the overhead console. Refer to Console Replacement - Overhead in Interior Trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.