Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 5.3 M, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESCOMPUTER/INTEGRATING SYSTEMSDIAGNOSTIC INFORMATION & PROCEDURESSCAN TOOL DATA LIST
2006 Isuzu Ascender S, 5.3 M, 4WD
Scan Tool Data List
2006 Isuzu Ascender S, 5.3 M, 4WDSECTION Scan Tool Data List
Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Body Control Module (BCM) Scan Tool Data List Operating Conditions: Ignition ON/Engine OFF |
|||
| Battery Voltage | Data | Volts | 12.5 |
| SWC Switch Voltage | Data | Volts | 12.5 |
| Ignition Accessory | Inputs | Active/Inactive | Active |
| Ignition 0 | Inputs | On/Off | On |
| Ignition 1 | Inputs | On/Off | On |
| Ignition 3 | Inputs | On/Off | On |
| Key in Ignition | Inputs | Yes/No | Yes |
| Left Rear Door Ajar Sw. | Inputs | On/Off | Off |
| Right Rear Door Ajar Sw. | Inputs | On/Off | Off |
| SWC Switch Power | Outputs | On/Off | On |
| GM Part Number | ID Information | Numeric | XXXXXXXX |
| Julian Date of Build | ID Information | Numeric | XXX |
| Year Module Built | ID Information | Numeric | XXXX |
| Driver/Passenger Door Module (DDM/PDM) Scan Tool Data List Operating Conditions: Ignition ON, Engine OFF |
|||
| Door Ajar Switch | Inputs | On/Off | Off |
| Liftgate Module (LGM) Scan Tool Data List Operating Conditions: Ignition ON, Engine OFF |
|||
| Liftgate Ajar Switch | Data | Closed/Ajar | Closed |
| Liftglass Ajar Switch | Data | Closed/Ajar | Closed |
| Endgate Module (EGM) Scan Tool Data List Operating Conditions: Ignition ON, Engine OFF |
|||
| Lower Left Ajar Switch | Input/Output | Closed/Ajar | Closed |
| Upper Left Ajar Switch | Input/Output | Closed/Ajar | Closed |
| Upper Right Ajar Switch | Input/Output | Closed/Ajar | Closed |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.