Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNCOMPONENT LOCATORSTEERING COLUMN DISASSEMBLED VIEW
2006 Isuzu Ascender S, 4.2 S, 4WD
Steering Column Disassembled View
2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Steering Column Disassembled View
| Callout | Component Name |
|---|---|
| 1 | Upper Trim Cover |
| 2 | Lower Trim Cover |
| 3 | Steering Column Closeout Trim Cover |
| 4 | Retaining Ring |
| 5 | SIR Coil |
| 6 | Wave Washer |
| 7 | Bearing Retainer |
| 8 | Cam Orientation Plate |
| 9 | Shaft Lock Shield Assembly |
| 10 | Turn Signal Cancel Cam Assembly |
| 11 | Upper Bearing Spring |
| 12 | Upper Bearing Inner Race Seat |
| 13 | Wire Harness Strap |
| 14 | Inner Race |
| 15 | Signal Switch Housing |
| 16 | Pan Head Tapping Screws |
| 17 | Turn Signal and Multifunction Switch Assembly |
| 18 | Steering Column Tilt Head Assembly |
| 19 | Pan Head Tapping Screws |
| 20 | TORX® Head Screw |
| 21 | Ignition Lock Cylinder Case |
| 22 | Theft Deterrent Control Module |
| 23 | Ignition Switch Assembly |
| 24 | Spring Guide |
| 25 | Tilt Spring |
| 26 | Theft Deterrent Control Module Electric Park Lock |
| 27 | Steering Shaft Assembly |
| 28 | Tilt Bumper |
| 29 | Pivot Pins |
| 30 | Steering Column Support Assembly |
| 31 | Coil Wire Harness Assembly |
| 32 | Coil Wire Harness Assembly (Export) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.