Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 619 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE DISCONNECTION AND CONNECTIONINSTALLATION PROCEDURE

2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Torrent and 2009 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Battery Cables & Terminal Nut

GM1822394

Courtesy of GENERAL MOTORS CORP.

Install the negative battery cable lead (1) to the battery.

CAUTION: Refer to Fastener Caution .

Tighten the negative battery cable terminal nut to 17 N.m (13 lb ft).

Fig 2: View Of Battery Shield

GM1822392

Courtesy of GENERAL MOTORS CORP.

Install the battery shield retainer tabs to the battery tray.

Fig 3: View Of Battery Shield Rear Snap Retainers

GM1822391

Courtesy of GENERAL MOTORS CORP.

Engage the battery shield rear snap retainers (1).

Fig 4: View Of ECM Retainer & Top Of Battery Shield

GM1822389

Courtesy of GENERAL MOTORS CORP.

Carefully position the ECM and retainer to the top of the battery shield.
Slide the ECM retainer forward, engaging the retainer to the battery shield.
Reset all of the customers radio station presets.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.