SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 464 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & COMPONENT CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSSEAT ADJUSTER SWITCH DRIVER
2006 Isuzu Ascender S, 4.2 S, 4WD

Seat Adjuster Switch Driver

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Seat Adjuster Switch Driver
WARNING: This page is about a different car, the 2008 Suzuki XL7, 2008 Pontiac Torrent, and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seat Adjuster Switch - Driver Connector End View
GM556473Courtesy of GENERAL MOTORS CORP.
Seat Adjuster Switch Driver

Pin Wire Circuit Function
A 2.0 RD/BK 542 Battery Positive Voltage
B 3.0 RD 285 Driver Seat Horizontal Motor Forward Control
C 3.0 BK 284 Driver Seat Horizontal Motor Rearward Control
D 3.0 D-GN 286 Driver Seat Front Vertical Motor Up Control
E 3.0 D-BU 287 Driver Seat Front Vertical Motor Down Control
F 3.0 L-BU 283 Driver Seat Rear Vertical Motor Down Control
G 2.0 BK 650 Ground
H 3.0 YE 282 Driver Seat Rear Vertical Motor Up Control
Connector Part Information 
  • OEM: 15326924
  • Service: 15306174
  • Description: 8-Way F GT 280 Series (BK)

Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.