SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 449 (HYDRAULIC BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE FLUID LEVEL INDICATOR SWITCH REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Pontiac Torrent and 2008 Chevrolet Equinox. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Fluid Level Sensor
    GM926579Courtesy of GENERAL MOTORS CORP.
  1. While noting the proper orientation, install the brake fluid level indicator switch to the master cylinder.
  2. Press the brake fluid level indicator switch firmly into the master cylinder reservoir, ensuring that the retaining tabs are fully engaged.
    3. Fig 2: View Of Brake Fluid Level Sensor Electrical Connector
    GM931316Courtesy of GENERAL MOTORS CORP.
  3. Connect the brake fluid level indicator switch electrical connector.
  4. Install the underhood electrical center bracket. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.