SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTRANSFER CASE SHIFT CONTROL SWITCH
2006 Isuzu Ascender S, 4.2 S, 4WD

Transfer Case Shift Control Switch

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Transfer Case Shift Control Switch
WARNING: This page is about a different car, the 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Transfer Case Shift Control Switch Connector End View
GM647976Courtesy of GENERAL MOTORS CORP.
Transfer Case Shift Control Switch

Pin Wire Circuit Function
A 0.35 PU/WH 1565 4 LO Indicator - Control
B 0.35 PU/WH 1382 LED Dimming Signal
C 0.35 BN/WH 230 Instrument Panel Lamps Dimming Control
D 0.35 BK 2250 Ground
E 0.35 TN/BK 1566 4 HI Indicator - Control
F 0.35 PK 1561 AWD Indicator Control
G 0.5 BN 1560 Neutral Indicator Control
H 0.5 BN 241 Ignition 3 Voltage
J 0.35 GY 596 5-Volt Reference
K - - Not Used
L 0.35 L-GN/BK 1563 2 HI Indicator - Control
M 0.35 L-BU 1693 Switch Signal
Connector Part Information 
  • OEM: 15332161
  • Service: 15306416
  • Description: 12-Way F GT 150 Series Unsealed (BK)
Terminal Part Information 
  • Pins: A-H, J, L-M
  • Terminal/Tray: 12191812/19
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 15315247/J-35616-2A (GY)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.