SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSSTEERING WHEEL SPEED/POSITION SENSOR
2006 Isuzu Ascender S, 4.2 S, 4WD

Steering Wheel Speed/Position Sensor

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Steering Wheel Speed/Position Sensor
WARNING: This page is about a different car, the 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Speed/Position Sensor Connector End View
GM280793Courtesy of GENERAL MOTORS CORP.
Steering Wheel Speed/Position Sensor

Pin Wire Circuit Function
1 0.35 GY 626 Steering Wheel Position Sensor 5-Volt Reference
2 0.35 OG/BK 556 Steering Wheel Position Sensor Signal Low Reference
3 0.35 L-GN 1763 Steering Wheel Position Signal A
4 0.35 D-BU 6047 Steering Wheel Position Signal B
5 - - Not Used
6 0.35 L-BU 1059 Steering Wheel Position Sensor Signal
7 0.35 BN 341 Ignition 3 Voltage
8 0.35 BK/WH 751 Ground
Connector Part Information 
  • OEM: 12052444
  • Service: 12101874
  • Description: 8-Way F Micro-Pack 100 Series Unsealed (BK)
Terminal Part Information 
  • Pins: 1-4, 6-8
  • Terminal/Tray: 12146447/3
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 12031876-1/J-35616-6 (BN)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.