SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 379 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSMEMORY SEAT MODULE - DRIVER X2 (W/MEMORY)
2006 Isuzu Ascender S, 4.2 S, 4WD

Memory Seat Module - Driver X2 (w/Memory)

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Memory Seat Module - Driver X2 (w/Memory)
WARNING: This page is about a different car, the 2008 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Memory Seat Module Connector End View - Driver X2 (w/Memory)
GM62469Courtesy of GENERAL MOTORS CORP.
Memory Seat Module - Driver X2 (w/Memory)

Pin Wire Circuit Function
A 2 D-GN 286 Driver Seat Front Vertical Motor Up Control
B 2 D-BU 287 Driver Seat Front Vertical Motor Down Control
C 2 L-BU 283 Driver Seat Rear Vertical Motor Down Control
D 2 YE 282 Driver Seat Rear Vertical Motor Up Control
E 2 L-GN 284 Driver Seat Horizontal Motor Rearward Control
F 2 TN 285 Driver Seat Horizontal Motor Forward Control
G 2 L-BU 277 Driver Seat Recline Motor Rearward Control
H 2 L-GN 276 Driver Seat Recline Motor Forward Control
Connector Part Information 
  • OEM: 12064998
  • Service: 15306189
  • Description: 8-Way F Metri-Pack 280 Series (BK)
Terminal Part Information 
  • Terminal/Tray: 12015858/4
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: 12094430/J-35616-4A (PU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.