SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 307 (FRONT SUSPENSION)REPAIR INSTRUCTIONSLOWER CONTROL ARM BALL JOINT REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Lower Ball Joint
    GM751170Courtesy of GENERAL MOTORS CORP.
  1. Install the lower ball joint and J 9519-E  , J 41435  , and J 45105-2  to the lower control arm. See Special Tools .
  2. Install the lower ball joint to the lower control arm using J 9519-E  , J 41435  , and J 45105-2  . See Special Tools .
  3. Remove J 9519-E  , J 41435  , and J 45105-2  from the lower control arm. See Special Tools .
  4. Install J 9519-E  and J 45105-1  to the lower ball joint. See Special Tools .
    5. Fig 2: Flaring Lower Ball Joint Flange
    GM754744Courtesy of GENERAL MOTORS CORP.
  5. Flare the lower ball joint flange using J 9519-E  and J 45105-1  . See Special Tools .
  6. Remove J 9519-E  and J 45105-1  from the lower ball joint. See Special Tools .
  7. Install the steering knuckle with wheel hub and bearing attached. Refer to Steering Knuckle Replacement (RWD)  or Steering Knuckle Replacement (4WD) .
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
  10. Check the front wheel alignment. Refer to Wheel Alignment Specifications .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.