SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 294 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT VIEWS & CONNECTOR END VIEWS)COMPONENT CONNECTOR END VIEWSTRAILER CONNECTOR
2006 Isuzu Ascender S, 4.2 S, 4WD

Trailer Connector

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Trailer Connector
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Trailer Connector End View
GM525095Courtesy of GENERAL MOTORS CORP.
Connector Part Information 
  • OEM: 15354653
  • Service: 15306164
  • Description: 7-Way F Metri-Pack 280 630 Series Sealed (BK)
Terminal Part Information 
  • Pins: B
  • Terminal/Tray: 15305232/23
  • Core/Insulation Crimp: B/3
  • Release Tool/Test Probe: J-38125-11A/J-35616-42 (RD)
  • Pins: A, D, F-G
  • Terminal/Tray: 12110847/4
  • Core/Insulation Crimp: C/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
  • Pins: C, E
  • Terminal/Tray: 12110845/4
  • Core/Insulation Crimp: F/5
  • Release Tool/Test Probe: 15315247/J-35616-4A (PU)
Pin Wire Circuit Function
A 0.35 L-GN 1624 Trailer Backup Lamps Control
B 0.35 WH 22 Ground
C 0.35 D-BU 47 Trailer Auxiliary Control
D 0.35 BK/WH 2619 Trailer Right Rear Turn/Stop Lamp Control
E 0.35 RD 742 Battery Positive Voltage
F 0.35 BN 2109 Trailer Park Lamps Control
G 0.35 L-BU/BK 2618 Trailer Left Rear Turn/Stop Lamp Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.