Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 272 (CELLULAR, ENTERTAINMENT, AND NAVIGATION)REPAIR INSTRUCTIONSRADIO REPLACEMENTREMOVAL PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD
Removal Procedure
2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
- Remove the 3 screws that retain the radio to the instrument panel (I/P).
- Partially remove the radio disengaging the radio rear alignment locator (1) to gain access to the electrical connectors.
- Disconnect the radio antenna cable.
- Disconnect the electrical connectors to the radio.
- Remove the radio from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.