Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (CELLULAR COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSNAVIGATION CONTROL PROCESSOR BRACKET REPLACEMENT (TRAILBLAZER EXT, ENVOY XL)REMOVAL PROCEDURE

2006 Isuzu Ascender S, 4.2 S, 4WD

Removal Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fold and tumble the right rear seat to a cargo position.
Leaving the electrical connectors attached, remove the communication interface module from the vehicle communication interface module (VCIM) bracket. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy, Bravada) or Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL) in Interior Trim.

Fig 1: Releasing Retaining Tab On VCIM Bracket

Courtesy of GENERAL MOTORS CORP.

Using a flat bladed tool, release the retaining tab (1) on the VCIM bracket.
Slide the VCIM bracket rearward until the retaining tabs are released from the seat bracket.
Remove the VCIM bracket from vehicle.

Fig 2: Removing VCIM Bracket

Courtesy of GENERAL MOTORS CORP.

Slide the VCIM bracket rearward until the retaining tabs are released from the seat bracket.
Remove the VCIM bracket from vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.