SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (INSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE)REPAIR INSTRUCTIONSCONSOLE REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Console
    GM741613Courtesy of GENERAL MOTORS CORP.
  1. If replacing the floor console base, instal the following:
    1. Instal the HVAC upper duct.
    2. Instal the cupholder.
    3. Instal the HVAC module and duct assembly.
    4. Instal the armrest.
    5. Instal the HVAC control module (if equipped).
  2. Position the center console to the vehicle.
  3. Adjust the parking brake to the full-up, or fully engaged position.
  4. Connect the electrical connectors as necessary.
  5. Lower the rear of the console and slide the console forward into position.
  6. Ensure that the 2 retaining ears on the front extensions of the console are fully engaged to the lower IP-Oldsmobile only.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the center console retaining screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  8. Install the console storage compartment. Refer to Console Storage Bin Replacement .
  9. Install the center console shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Oldsmobile, Buick) .
  10. Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement in Automatic Transmission.
  11. Install the rubber ash tray inserts and rubber mat to the console.
  12. Remove the bocks from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.