SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSGENERATOR REPLACEMENT (4.2L ENGINE)REMOVAL PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Removal Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Removal Procedure
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
  2. Remove the drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 4.2L.
    3. Fig 1: Rear Of Generator (Alternator) View
    GM754357Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the battery positive cable nut (1) on the generator.
    4. Fig 2: View Of Engine Lift Hook & A/C Bracket Bolt
    GM754344Courtesy of GENERAL MOTORS CORP.
  4. Remove the A/C line mounting bracket bolt at the engine life hook.
    5. Fig 3: View Of Engine Lift Bracket
    GM750247Courtesy of GENERAL MOTORS CORP.
  5. Remove the right engine lift hook bolts and remove the lift hook.
    6. Fig 4: View Of Generator & Mounting Bolts
    GM753668Courtesy of GENERAL MOTORS CORP.
  6. Remove the 3 generator mounting bolts and remove the generator.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.