Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connecting Procedure
2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Connecting Procedure
- Verify that all electrical components are off such as interior lights, all doors are closed, the underhood lamp, etc.
- Clean any corrosion from the negative battery cable using a wire brush.
- Position the negative battery cable (5) to the battery.NOTE: Refer to Fastener Notice in Cautions and Notices.
- Tighten negative battery cable bolt.
Tighten: Tighten the bolt to 15 N.m (11 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.