SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSISBRAKESANTILOCK BRAKE SYSTEM WITH TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEMREPAIR INSTRUCTIONSTRACTION CONTROL SWITCH REPLACEMENT (BUICK)INSTALLATION PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure
    Fig 1: Removing/Installing Traction Control Switch (Oldsmobile, Buick)
    GM1265375Courtesy of GENERAL MOTORS CORP.
  1. Install the switch (1) to the trim plate.
    2. Fig 2: Removing/Installing Traction Control Switch Retaining Ring (Oldsmobile, Buick)
    GM1265370Courtesy of GENERAL MOTORS CORP.
  2. Install the retaining ring to the switch, ensuring the ring tabs are fully seated.
    3. Fig 3: Traction Control Switch Electrical Connector (Oldsmobile, Buick)
    GM1265379Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the switch.
  4. Install the shift lever bezel. Refer to Console Shift Lever Bezel Replacement (Buick) in Instrument Panel, Gages, and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.