Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Intermediate Shaft Bearing Assembly Oil Seal Replacement: Notes
2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Notes
Tools Required
- J 2619-01 Slide Hammer with Adapter
- J 29369-2 Bushing and Bearing Remover (2-3 in). See Special Tools .
- J 45225 Axle Seal Installer. See Special Tools .
- J 45359 Axle Seal Installer
- J 6125-B Slide Hammer. See Special Tools .
- J 8092 Universal Driver Handle 3/4 in - 10. See Special Tools .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.