Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBODY FRONT ENDREPAIR INSTRUCTIONSFENDER REPLACEMENT - FRONTINSTALLATION PROCEDURE

2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure

Fig 1: Fender Bracket & Retaining Clips

Courtesy of GENERAL MOTORS CORP.

If replacing the body to fender seal, position the seal to the vehicle.
Ensure that the integral clips (1) on the seal are seated into the fender bracket (2).

Fig 2: Fender Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Position the fender to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts that retain the fender to the vehicle.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 3: View Of Side Hood Bumper

Courtesy of GENERAL MOTORS CORP.

Install the hood bumper to the vehicle.
Install the rocker panel molding. Refer to Molding Replacement - Rocker Panel (TrailBlazer EXT, Envoy XL) or Molding Replacement - Rocker Panel (TrailBlazer, Envoy) in Exterior Trim.
Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement .
Install the assist step, if applicable. Refer to Assist Step Replacement in Frame and Underbody.
Remove the protective tape.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.