SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU2006ASCENDER S, 4.2 S, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTENTERTAINMENT SYSTEMSREPAIR INSTRUCTIONSANTENNA CABLE REPLACEMENTINSTALLATION PROCEDURE
2006 Isuzu Ascender S, 4.2 S, 4WD

Installation Procedure

2006 Isuzu Ascender S, 4.2 S, 4WDSECTION Installation Procedure
    Fig 1: Radio Antenna Cable Assembly
    GM718023Courtesy of GENERAL MOTORS CORP.
  1. Install the radio antenna cable assembly to the vehicle.
  2. Pass the antenna cable and grommet assembly through the fender opening.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the radio antenna cable assembly retaining screws.

    Tighten:  Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).

  4. Close the hood.
  5. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
    6. Fig 2: Cowl Opening
    GM718019Courtesy of GENERAL MOTORS CORP.
  6. Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
  7. Install the antenna cable grommet assembly to the cowl opening.
  8. Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
    9. Fig 3: View Of Radio Antenna Cable To Radio Extension Cable
    GM734416Courtesy of GENERAL MOTORS CORP.
  9. Install the radio antenna cable (2) to the radio extension cable.
  10. Close the I/P compartment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.