Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Conditions For Setting DTC
1996 Isuzu Trooper S, AutomaticSECTION Conditions For Setting DTC
- DTCs P0107, P0108, P0106, P1106, P1107, P0122 and P0123 are not present.
- Not in Park or Neutral.
- TP sensor angle is greater than 10 percent.
- Engine vacuum is between zero and 10.2 in. Hg.
- Engine speed is between 3000 RPM and 5000 RPM.
- Transmission speed is less than zero RPM.
- All conditions must be present for 5 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.