Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU1996TROOPER S, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 40 (ENGINE CONTROLS - BASIC TESTING - 2.6L 4-CYL)FUEL SYSTEMFUEL PUMP RELAY TEST
1996 Isuzu Trooper S, Automatic
Fuel Pump Relay Test
1996 Isuzu Trooper S, AutomaticSECTION Fuel Pump Relay Test
WARNING: This page is about a different car, the 1996 Isuzu Rodeo. However, it is still accessible from the selected car via links, so may be relevant.
- Power from charging circuit relay runs through fuse/relay box fuse No. 5 and diode box "A" to energize fuel pump relay. Relay is also energized from diode box "A" through oil pressure switch circuit in case of charging system failure.
- When energized, fuel pump relay closes power circuit from main fuse No. 1, through fuse No. 2, through fuel pump relay to fuel pump. See appropriate wiring diagram in WIRING DIAGRAMS section.
- To test relay, remove fuel pump relay from fuse/relay box on right fender panel. Using jumper wires, ground terminal No. 4, and apply battery voltage to terminal No. 5. See Figure . There should be continuity between terminals No. 1 and 3 with relay energized. If continuity does not exist, replace relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.