Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brake Light Switch
1996 Isuzu Trooper S, AutomaticSECTION Brake Light Switch
- Disconnect brake light switch harness connector. Using an ohmmeter, check continuity between brake light switch terminals No. 1 and 2. See Figure . Continuity should not be present. Depress brake pedal or activate brake light switch, continuity should be present. Replace switch if not as specified.
- Check for battery voltage at brake light switch connector. If battery voltage is not present check, 20A Stop-Hazard fuse in fuse box. If fuse is okay, check battery feed wire for an open or short. Repair as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.