Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Activating System
1996 Isuzu Oasis SSECTION Activating System
- Ensure ignition switch is in OFF position. Reconnect all Orange SRS connectors that were disconnected. Position Orange SRS connector back into holder on steering column. On passenger-side air bag, place Orange SRS connectors back into position near passenger air bag module. Install glove box.
- On all models, install steering column lower casing cover. Connect negative battery cable. System is now activated. Perform system operation check to ensure system is functioning properly and no fault codes are set. See SYSTEM OPERATION CHECK .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.