Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preliminary Procedure
1996 Isuzu Oasis SSECTION Preliminary Procedure
- Raise and support vehicle. Ensure brakes do not drag. Turn ignition switch to ON position and ensure ABS indicator light comes on. If ABS indicator light does not come on, go to appropriate flow chart. See ABS SELF-DIAGNOSTIC FLOW CHARTS .
- Turn ignition switch to OFF position. Connect ABS Tester (07HAJ-SG0010B) to Orange 6-pin ABS test connector, located under glove box. Put transmission in Park (A/T) or Neutral (M/T).
- Start engine and release parking brake. Place mode selector to "1" position. Push START TEST button. See Fig 1. TEST IN PROGRESS light should come on. ABS indicator light should not come on when TEST IN PROGRESS light is on. If ABS indicator light comes on, confirm DTC and perform appropriate self-diagnostic flow chart. If tester lights do not illuminate, ABS tester is faulty.CAUTION: DO NOT move mode selector switch while TEST IN PROGRESS light is on. ABS tester could be damaged.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.