Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU1996OASIS SREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATS - POWERCOMPONENT TESTINGSWITCH
1996 Isuzu Oasis S
Component Testing: Switch
1996 Isuzu Oasis SSECTION Switch
- Turn ignition off. Remove driver's seat side cover. Disconnect 5-pin harness connector from power seat up-down switch. Remove power seat switch.
- Using an ohmmeter, check for continuity between specified switch terminals while operating switch. See POWER SEAT SWITCH CONTINUITY table. SeeFig 1 . Replace power seat switch if continuity is not as specified.
POWER SEAT SWITCH CONTINUITY
| Function | Between Terminals No. |
|---|---|
| UP | 1 & 2; 4 & 5 |
| DOWN | 1 & 4; 2 & 3 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.