Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU1992RODEO LS, 4WD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONCLUTCHESADJUSTMENTSCLUTCH PEDAL FREE PLAYMECHANICALLY OPERATED
1992 Isuzu Rodeo LS, 4WD, Standard
Mechanically Operated
1992 Isuzu Rodeo LS, 4WD, StandardSECTION Mechanically Operated
- Pull outer cable toward front of vehicle and secure. Turn adjusting nut until it contacts rubber damper. See Fig 1 . Operate clutch pedal several times. Again pull outer cable toward front of vehicle.
- Retighten adjusting nut. Back off adjusting nut to obtain .12-.20" (3-5 mm) clearance between adjusting nut and rubber damper washer. Release outer cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.