Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Code 14 - Cts Circuit (High Temperature Indicated): Notes
Coolant temperature sensor controls signal voltage to the ECM. The ECM applies voltage on circuit No. C10 to the sensor. When engine is cold, thermistor resistance is high and ECM will see a high signal voltage. As engine warms, sensor resistance decreases and ECM will see a low signal voltage. When engine reaches normal operating temperature, signal voltage will be approximately 1.5-2.0 volts at the ECM.
- Code 14 will set if signal voltage indicates a coolant temperature greater than 275°F (135°C) for 6 seconds.
- This determines if circuit No. C10 is shorted to ground, which will cause the conditions for Code 14.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.