Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSISUZU1985I-MARK 2D HATCHBACK, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMEGR FUNCTION TESTING - GASOLINECOMPONENT TESTINGBACK PRESSURE TRANSDUCERI-MARK, P'UP & TROOPER II
1985 Isuzu I-Mark 2D Hatchback, Standard
I-Mark, P'UP & Trooper II
1985 Isuzu I-Mark 2D Hatchback, StandardSECTION I-Mark, P'UP & Trooper II
Apply a pressure above 0.07 psi (0.005 kg/cm2 ) to port connected to back pressure signal pipe and check transducer for leaks. If leaks are noted, replace transducer as an assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.