Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
VR30DDTT engine
- CHECK DTC PRIORITY
If DTC P1568 is displayed with DTC UXXXX, P0605 or P0607, first perform the confirmation procedure for DTC UXXXX, P0605 or P0607.
Is applicable DTC detected?
YES
Perform diagnosis of applicable DTC.
- DTC UXXXX: Refer to DTC Index (For turbo high pressure model) or DTC Index (For turbo low pressure model).
- DTC P0605: Refer to DTC Description .
- DTC P0607: Refer to DTC Description .
NO
GO TO 2.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Step 4 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Press MAIN switch on ICC steering switch.
- Drive the vehicle at more than 40 km/h (25 MPH).CAUTION: Always drive vehicle at a safe speed.
- Press SET/COAST switch.
- Check DTC.
Is DTC detected?
YES
Refer to DTC Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Inspection .
NO
Confirmation after repair: INSPECTION END
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
