Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 8 (ENGINE MECHANICAL (5.6L))UNIT DISASSEMBLY AND ASSEMBLYOIL PAN (UPPER)EXPLODED VIEW

2019 Infiniti Q70 3.7 Luxe, AWD

Exploded View

2019 Infiniti Q70 3.7 Luxe, AWDSECTION Exploded View

WARNING: This page is about a different variant/trim than selected.

Fig 1: Oil Pan (Upper) 2WD With Torque Specifications

Courtesy of NISSAN NORTH AMERICA, INC.

1.	Oil level gauge	2.	Oil level gauge guide	3.	O-ring
4.	Oil cooler	5.	Connector bolt	6.	Oil filter
7.	Drain plug washer	8.	Oil pan (lower)	9.	Baffle plate
10.	Oil strainer	11.	Gasket	12.	Engine oil temperature sensor
13.	Engine oil pressure sensor	14.	Rear plate cover	15.	Crankshaft position sensor (POS)
16.	O-ring	17.	O-ring	18.	Baffle plate
A.	Comply with the assembly procedure when tightening. Refer to Exploded View	B.	Comply with the assembly procedure when tightening. Refer to Removal and Installation	C.	Oil pump side
	: Oil pan side
Refer to Components for symbols in the figure.

Fig 2: Oil Pan (Upper) AWD With Torque Specifications

Courtesy of NISSAN NORTH AMERICA, INC.

1.	Oil level gauge	2.	Oil level gauge guide	3.	O-ring
4.	Oil cooler	5.	Connector bolt	6.	Oil filter
7.	Drain plug washer	8.	Oil pan (lower)	9.	Oil strainer
10.	Gasket	11.	Engine oil temperature sensor	12.	Engine oil pressure sensor
13.	O-ring	14.	Axle pipe	15.	O-ring
16.	Rear plate cover	17.	Crankshaft position sensor (POS)	18.	O-ring
19.	O-ring	20.	Baffle plate	21.	Baffle plate
A.	Comply with the assembly procedure when tightening. Refer to Exploded View	B.	Comply with the assembly procedure when tightening. Refer to Removal and Installation	C.	Oil pump side
	: Oil pan side
Refer to Components for symbols in the figure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.