Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK ASCD BRAKE SWITCH FUNCTION
WITH CONSULT
- Turn ignition switch ON.
- Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
- Check "BRAKE SW1" indication under the following conditions.
Monitor item
Condition
Indication
BRAKE SW1
(ASCD brake switch)
Brake pedal
Slightly depressed
OFF
Fully released
ON
WITHOUT CONSULT
- Turn ignition switch ON.
- Check the voltage between ECM harness connector terminals as per the following.
ECM
Condition
Voltage (V)
+
-
Connector
Terminal
Connector
Terminal
M56
140
(ASCD brake switch signal)
F116
10
Brake pedal
Slightly depressed
Approx. 0
Fully released
Battery voltage
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to Diagnosis Procedure .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.