Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection (ASCD Brake Switch)
- CHECK ASCD BRAKE SWITCH-I
- Turn ignition switch OFF.
- Disconnect ASCD brake switch harness connector.
- Check the continuity between ASCD brake switch terminals under the following conditions.
Terminals
Condition
Continuity
1 and 2
Brake pedal
Fully released
Existed
Slightly depressed
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- CHECK ASCD BRAKE SWITCH-II
- Adjust ASCD brake switch installation. Refer to Inspection and Adjustment .
- Check the continuity between ASCD brake switch terminals under the following conditions.
Terminals
Condition
Continuity
1 and 2
Brake pedal
Fully released
Existed
Slightly depressed
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ASCD brake switch. Refer to Exploded View .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.