SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 12 (ENGINE CONTROL SYSTEM (5.6L) (DTC/CIRCUIT DIAGNOSIS) (9 OF 9))DTC/CIRCUIT DIAGNOSISIGNITION SIGNALCOMPONENT INSPECTION (CONDENSER)
2019 Infiniti Q70 3.7 Luxe, AWD

Component Inspection (Condenser)

2019 Infiniti Q70 3.7 Luxe, AWDSECTION Component Inspection (Condenser)
WARNING: This page is about a different variant/trim than selected.
  1. CHECK CONDENSER 
    1. Turn ignition switch OFF.
    2. Disconnect condenser harness connector.
    3. Check resistance between condenser terminals as per the following.

      Terminals

      Resistance

      1 and 2

      Above 1 MOhm [at 25 deg.C (77 deg.F)]

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace condenser.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.