Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
2019 Infiniti Q70 3.7 Luxe, AWDSECTION Component Function Check
WARNING: This page is about a different variant/trim than selected.
- INSPECTION START
Turn ignition switch to START.
Are any cylinders ignited?
YES
GO TO 2.
NO
Proceed to Diagnosis Procedure .
- CHECK FUEL INJECTOR FUNCTION
WITH CONSULT
- Start engine.
- Perform "POWER BALANCE" in "ACTIVE TEST" mode with CONSULT.
- Check that each circuit produces a momentary engine speed drop.
WITHOUT CONSULT
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to Diagnosis Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.