SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 11 (ENGINE CONTROL SYSTEM (5.6L) (DTC/CIRCUIT DIAGNOSIS) (5 OF 9))DTC/CIRCUIT DIAGNOSISDTC P060A: ECMDTC LOGICDTC DETECTION LOGIC
2019 Infiniti Q70 3.7 Luxe, AWD

DTC Detection Logic

2019 Infiniti Q70 3.7 Luxe, AWDSECTION DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detecting condition

Possible cause

P060A

CONTROL MODULE

(Internal control module monitoring processor performance)

ECM internal monitoring processor is malfunctioning.

ECM

DTC CONFIRMATION PROCEDURE 

  1. PRECONDITIONING 
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is 11 V or more with ignition switch ON.

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and wait at least 10 seconds.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Repeat step 1 and 2 for 5 times.
    4. Turn ignition switch ON.
    5. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Refer to Diagnosis Procedure .

    NO

    INSPECTION END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.