SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSINFINITI2019Q70 3.7 LUXE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 11 (ENGINE CONTROL SYSTEM (5.6L) (DTC/CIRCUIT DIAGNOSIS) (5 OF 9))DTC/CIRCUIT DIAGNOSISDTC P0456: EVAP CONTROL SYSTEMDTC LOGICDTC DETECTION LOGIC
2019 Infiniti Q70 3.7 Luxe, AWD

DTC Detection Logic

2019 Infiniti Q70 3.7 Luxe, AWDSECTION DTC Detection Logic
WARNING: This page is about a different variant/trim than selected.

This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF.

If ECM judges there are no leaks, the diagnosis will be OK.

G06933051Courtesy of NISSAN NORTH AMERICA, INC.

DTC No.

Trouble diagnosis name

(Trouble diagnosis content)

DTC detecting condition

Possible cause

P0456

Evaporative emission control system leak
  • EVAP system has a leak.
  • EVAP system does not operate properly.
  • Incorrect fuel tank vacuum relief valve
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or does not close.
  • Foreign matter caught in fuel filler cap.
  • Leak is in line between intake manifold and EVAP canister purge volume control solenoid valve.
  • Foreign matter caught in EVAP canister vent control valve.
  • EVAP canister or fuel tank leaks
  • EVAP purge line (pipe and rubber tube) leaks
  • EVAP purge line rubber tube bent
  • Loose or disconnected rubber tube
  • EVAP canister vent control valve and the circuit
  • EVAP canister purge volume control solenoid valve and the circuit
  • Fuel tank temperature sensor
  • O-ring of EVAP canister vent control valve is missing or damaged
  • EVAP canister is saturated with water
  • EVAP control system pressure sensor
  • Refueling EVAP vapor cut valve
  • ORVR system leaks
  • Fuel level sensor and the circuit
  • Foreign matter caught in EVAP canister purge volume control solenoid valve
CAUTION:
  • Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may illuminate.
  • If the fuel filler cap is not tightened properly, the MIL may illuminate.
  • Use only a genuine NISSAN rubber tube as a replacement.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.