Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK FUEL TANK TEMPERATURE SENSOR
- Turn ignition switch OFF.
- Disconnect "fuel level sensor unit and fuel pump (main)" harness connector.
- Remove fuel level sensor unit. Refer to Exploded View .
- Check resistance between "fuel level sensor unit and fuel pump (main)" terminals by heating with hot water as shown in the figure.
Terminals
Condition
Resistance (kOhm)
4 and 5
Temperature [ deg.C (deg.F)]
20 (68)
2.3 - 2.7
50 (122)
0.79 - 0.90
Is the inspection result normal?
YES
GO TO 2.
NO
Proceed to Diagnosis Procedure .
- CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .
Is the inspection result normal?
YES
INSPECTION END
NO
Proceed to Diagnosis Procedure .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.