Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal and Installation: Removal
2019 Infiniti Q70 3.7 Luxe, AWDSECTION Removal
WARNING: This page is about a different variant/trim than selected.
- Remove hoodledge cover (RH) and cowl top cover (RH). Refer to Removal and Installation .
- Remove the battery and battery tray. Refer to Removal and Installation .
- Remove VVEL control module bracket bolts (A).
- Remove the ground harness fix bolt (B).
- Remove VVEL control module bracket (1).
- Disconnect VVEL control module harness connector.
- Remove the fix bolts (A). And then separate VVEL control module (1), ground harness (2) and VVEL control module bracket (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.