Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
- CHECK BRAKE FLUID LEVEL SWITCH
- Turn the ignition switch OFF.
- Disconnect brake fluid level switch harness connector.
- Check continuity between terminals of brake fluid level switch.
Brake fluid level switch
Condition
Continuity
Terminal
1 - 2
When brake fluid level in reservoir tank is within the specified level.
Not existed
When brake fluid level in reservoir tank is less than the specified level.
Existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace reservoir tank. Refer to Disassembly and Assembly .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.