Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
- CHECK FUNCTION
- Select "MIR/SEN LH U-D", "MIR/SEN LH R-L" in "Data monitor" with CONSULT.
- Check mirror sensor (driver side) signal under the following condition.
Monitor item
Condition
Value
MIR/SEN LH U-D
Door mirror (driver side)
Change between
3.4 [V] (close to peak)
0.6 [V] (close to valley)
MIR/SEN LH R-L
Change between
0.6 [V] (close to left edge)
3.4 [V] (close to right edge)
Is the indication normal?
YES
INSPECTION END
NO
Perform diagnosis procedure. Refer to Diagnosis Procedure .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.